1. Introduction: The B-type chemical grouting pump is a lightweight, easy-to-carry hand pump. It is a commonly used equipment in chemical grouting construction. It is used to waterproof and reinforce concrete defects such as honeycombs, holes, cracks, and deformation joint leakage. . This pump has been widely used in a large number of projects and has achieved good engineering benefits.
2. Main features:
, smart, light, easy to carry
, simple to operate, no need for power supply or air source
, reasonable structure, easy to disassemble, clean and maintain
, The grouting pressure is adjustable
, equipped with a liquid level meter, and the grouting amount can be calculated
3. Scope of application:
Suitable for the grouting of various chemical grouting materials, as well as for water conservancy, hydropower, tunnels, etc. Waterproof reinforcement treatment of concrete defects in subways, civil air defense, metallurgical engineering, industrial and civil buildings.
4. Performance indicators:
Project indicators
Maximum grouting pressure
.
Grout output (L/min) )
.
Grouting fluid viscosity (.)
Pump solution volume (liter)
/>
.
Pump weight
.
5. Construction technology:
, initial use , first use acetone or xylene to clean the oil in the pump.
. Fill the oil cup at the lower end of the pressure gauge with engine oil and tighten the oil cup.
Pour the filled slurry into the slurry cylinder, cover the cylinder cover, and pull up the buckle.
Connect the plastic grouting pipe and the grouting pipe. The grouting will drive out the air in the pipe. Connect the other end of the grouting pipe to the pre-embedded grouting pipe. Tie the outside of the joint tightly with a thin iron wire.
, control the pressure for grouting according to the design requirements.
After the grouting is completed, clean the pump with solvent, then apply engine oil on the moving parts and assemble it for later use.
6. Precautions:
Since the chemical solvent in the slurry will swell the rubber sealing ring on the plunger, causing lax sealing and other phenomena, it needs to be checked and replaced frequently.
Remarks: Rubber sealing ring specifications:*. *.
Manual chemical grout pump BL100