1. Product features: The watertight seal has the advantages of being moisture-proof and impermeable, quick to plug leaks, firmly bonded, non-toxic and harmless. The material is susceptible to moisture and should be sealed and stored in a dry place.
2. Scope of use:
The water does not leak and is suitable for seepage surfaces and water leaks. For non-permeable surfaces, it is best to use slow-setting water to prevent leakage. For large-area waterproofing, it is advisable to use the composite waterproof coating produced by our company to form an elastic waterproof layer.
3. Material preparation:
The scraping material is divided into powder: water: .~. Stir for ~ minutes (preferably with a mixer) to form a uniform putty without any lumps or cornstarch.
Mix the leak-stopping material into powder: water:. and knead into a ball. In order to ensure the quick setting of this material, when the ambient temperature is lower than ℃, use warm water of about ℃ for seasoning.
4. Construction operations:
. Penetration surface: Before loading, dry the base surface with a dry cloth and load the material quickly.
. Use a trowel to apply the first layer of material first. If there is water leakage, leave it alone
. After the coating hardens (hand pressure will not leave fingerprints), spray it with water (but there should be no accumulation of water)
br/>. Then use a scraper or trowel to apply the second layer of material
. If there is still water seepage in some areas, use another layer of material to block it until no leakage occurs.
When loading, use a little force and go back and forth several times to make it dense, and pay attention to the overlap. The dosage for each layer is approximately /, and the total dosage is approximately /.
. Water leak: According to the shape of the hole, knead the leak-stopping material into a ball slightly smaller than the size of the hole. Leave it for a few minutes (it should be hard when you pinch it with your hands), then stuff it into the leak, and squeeze it with a wooden stick. Smash lightly to squeeze it all around to stop the leakage instantly. Then apply a layer of scraping material outside and around the opening at about c. Before plugging the leak, it is best to waterproof the surrounding areas that may leak, and then plug the leak after the waterproof layer hardens, otherwise water may be squeezed out from the surrounding area.
5. Surface treatment:
. Penetration surface: The base surface must be fully moistened to saturation (no longer absorbing water), and must be clean, strong, flat, but not too smooth.
. Leakage: Use a chisel or impact drill to drill a groove or hole to a certain depth (about ~ c) and make the inside as large as possible and the outside as small as possible. The opening should be as small as possible, but it must be new. stubble, then rinse.
6. Moisturizing and curing:
Moisturizing and curing should be carried out immediately after the coating hardens to prevent powdering. The curing methods can be: spraying water, covering with wet objects, applying curing fluid, etc. Care should be taken during the first curing to avoid damaging the coating. The curing lasts for ~ days. It can be cured naturally in humid places (such as basements with water leakage, etc.).
7. Precautions:
If the waterproof layer still leaks water over a large area after construction, it must be moisture condensation, which will disappear after a few days of drying. Special reminder: construction is not suitable on rainy days!
Bolong water does not leak